HP 9000 rp3410 - Figure 3-13 Top Cover Alignment Mark; Figure 3-14. Replacing the Top Cover on a Pedestal-Mounted Server

Installing the System
Installing Additional Components
Chapter 3
70
Figure 3-13 Top Cover Alignment Mark
Step 2. Place the top cover on the chassis and slide it toward the front of the server until the blue release
lever snaps in place.
Figure 3-14 Replacing the Top Cover on a Pedestal-Mounted Server
Replacing the Side Cover on a Pedestal-Mounted Server
To replace the side cover, follow these steps:
Step 1. Align the cover’s mounting holes with the matching tabs on the server chassis.
To replace cover,
align front edge here
then slide forward