HP 9000 rp3410 - Replacing a Hard Disk Drive; Figure 6-24 Removing the Disk Drive

Chapter 6
Removing and Replacing Components
Removing and Replacing an Internal Hard Disk Drive
168
Step 4. Pull outward on the release lever to remove the drive from the server (Figure 6-23; Figure 6-24).
Figure 6-24 Removing the Disk Drive
Replacing a Hard Disk Drive
To install or replace a hard disk drive, follow these steps:
Step 1. If the server is powered on and the OS is running, prepare the OS to have the disk drive removed.
(See your OS documentation for instructions on preparing the OS for removing and inserting hard
drives.)
Step 2. If you are locking the hard drive in place, remove the cover.
CAUTION Replace the top cover within five minutes to prevent damage to the server
components.