HP 9000 rp3410 - Figure 6-5 Aligning the Top Cover on a Rack-Mounted Server; Figure 6-6 Closing the Top Cover on a Rack-Mounted Server

Chapter 6
Removing and Replacing Components
Removing and Replacing Server Covers and Bezel
154
Step 1. Align the front edge of the top cover with the alignment mark on the optical drive bay.
Figure 6-5 Aligning the Top Cover on a Rack-Mounted Server
Step 2. Grasp the blue release lever and slide the cover toward the front of the server until the lever snaps
into place.
Figure 6-6 Closing the Top Cover on a Rack-Mounted Server
Step 3. Slide the server into the rack enclosure and reconnect the power and external cables.
To replace cover,
align front edge here
then slide forward