HP 9000 rp3410 - Powering the Server on and off; Power States; Table 1-16 Ilo MP Card LAN Connector Pinouts; Table 1-17 Power States

Chapter 1
Overview
Powering the Server On and Off
44
Table 1-16 lists the iLO MP card LAN connector pinouts.
Powering the Server On and Off
This section provides information on how to power off and power on the server.
Power States
The server has three power states:
• Standby power
• Full power
•Off
Plug the power cord into the appropriate receptacle on the rear of the server to achieve the standby power
state; the front panel power button is not turned on. Full power occurs when the power cord is plugged into
the appropriate receptacle, and either the power is activated through the iLO MP PC command, or the power
button is activated. In the off state, the power cords are not plugged in.
Table 1-17 lists the server power states.
Table 1-16 iLO MP Card LAN Connector Pinouts
Pin Number Signal Description
1TXP
2TXN
3RXP
4Not used
5Not used
6RXN
7Not used
8Not used
Table 1-17 Power States
Power States
Power Cable
Plugged Into
Receptacle?
Power Activated through the
iLO MP PC Command; or
Front Panel Power Button
Activated?
Standby dc
Voltage
Applied?
dc Voltage
Applied?
Standby power Yes No Yes No
Full power Yes Yes Yes Yes
Off No No No No