HP 9000 rp3410 - Figure 6-19 Releasing the Power Supply Retaining Clip; Removing the Power Supply

Chapter 6
Removing and Replacing Components
Removing and Replacing the Power Supply
164
Removing the Power Supply
To remove the power supply, follow these steps:
Step 1. Remove the front bezel from the server. (See “Removing and Replacing Server Covers and Bezel” on
page 151.)
Step 2. Press the power supply retaining clip to unlatch the power supply release lever.
Figure 6-19 Releasing the Power Supply Retaining Clip
Power Supply 1
Power Supply 2