HP 9000 rp3410 - Removing and Replacing the LED Status Panel; Removing the LED Status Panel; Replacing the LED Status Panel; Figure 6-63 Removing the LED Status Panel

Chapter 6
Removing and Replacing Components
Removing and Replacing the LED Status Panel
213
Removing and Replacing the LED Status Panel
The LED status panel card contains the server and diagnostic LEDs.
Removing the LED Status Panel
Step 1. Power off the server and disconnect all power and external cables.
Step 2. Remove the top cover. (See “Removing and Replacing Server Covers and Bezel” on page 151.)
Step 3. Disconnect the LED status panel’s controller cable.
Step 4. Unscrew the two LED status panel mounting screws and remove the panel.
Figure 6-63 Removing the LED Status Panel
Replacing the LED Status Panel
Step 1. Replace the LED status panel in the server and screw in the two LED status panel mounting
screws.
Step 2. Connect the LED status panel controller cable.
Step 3. Replace the top cover.
Step 4. Reconnect all power and external cables.
Step 5. Turn on the server and verify that the server and power LEDs light up.