EasyManua.ls Logo

HP 9000 rp3410 - PCI Riser; Internal Core I;O; External Core I;O; Power Supply Unit

HP 9000 rp3410
254 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 1
Overview
Detailed Server Description
23
Total memory bandwidth is 8.5 GB/s, split across two 4.25 GB/s memory buses.
Open page memory latency is 80 nanoseconds.
PCI Riser
Two (HP 9000 rp3410 server) or four (HP 9000 rp3440 server) independent PCI-X 133 MHz 64-bit 3.3V 15W
slots. No 5V card and hot-pluggable support.
Internal Core I/O
The following is supported on the HP 9000 rp3410 and rp3440 servers:
Dual-channel SCSI U160 interface, two internal 68-pin connectors, one 68-pin external connector.
SCSI backplane configured either as two channels with 2+1 drives. A SAF-TE accessory (currently not
available) is required to configure the SCSI backplane as one channel with three drives.
Three internal SCSI drive connectors are of the 80-pin type and provide drive electrical hot-pluggable
capability.
SCSI backplane is designed to support a SCSI management piggy board accessory that provides a SCSI
management SAF-TE chip and shunts the backplane's channels A and B to provide three disks on
channel A and leave only the external connector on channel B.
One internal IDE connector for a slim-line optical device (CD and DVD).
No floppy connector.
External Core I/O
The following is supported on the HP 9000 rp3410 and rp3440 servers:
One SCSI U160 68-pin connector.
One 10/100/1000Base-T Ethernet LAN connectors for copper cable.
Four USB 2.0 ports.
Three DB-9 ports (console, UPS, and modem) through a 3-connector M cable.
Power Supply Unit
The following is supported on the HP 9000 rp3410 and rp3440 servers:
650W output power.
The power supply is split in a front end block (the actual power supply case) that converts the line voltage
into a high dc voltage and back end voltage regulation modules (on the motherboard) that step down the
front end dc voltage to the required voltages.
Redundant and hot-pluggable power supplies (front end block only).
System Board Manageability
The following is supported on the HP 9000 rp3410 and rp3440 servers:
Baseboard Management Controller (BMC).
Temperature monitoring and fans regulation by BMC.

Table of Contents

Other manuals for HP 9000 rp3410

Related product manuals