HP 9000 rp3410 - Figure 3-38 Aligning the Processor Module

Installing the System
Installing Additional Components
Chapter 3
95
NOTE Protective covers can be installed to protect connector pins. These covers can be
saved for future use.
Step 7. Use the four locator posts on the heatsink and the turbo fan power cable to properly align the fan
and dual processor module on the system board. The four locator posts will fit in locator holes on
the system board processor module mount. The turbo fan power cable must be positioned so that it
is located on the side of the heatsink that faces the front of the server.
Figure 3-38 Aligning the Processor Module
Step 8. Use the special CPU install tool (2.5 mm driver or Allen Wrench) to lock the dual processor module
in place on the system board. To do this, insert the CPU install tool into the hole that runs down the
side of the heatsink and rotate it clockwise 180 degrees.