HP 9000 rp3410 - Powering on the Server; Powering off the Server

Installing the System
Powering the Server ON and OFF
Chapter 3
119
NOTE If the power restore feature is set to Always On through the iLO MP PR command, the server
automatically powers on to the full power state when the power cord is plugged in to the server.
Powering On the Server
Power on the server to full power using the following methods if the server is in the standby power state:
•iLO MP PC command
• Power button
Powering On the Server Using the iLO MP PC Command
NOTE If the power restore feature is set to Always On through the iLO MP PR command, the server
automatically powers on to the full power state when the power cord is plugged in to the server.
To power on the server using the iLO MP PC command, follow these steps:
Step 1. Plug all power cables into the receptacles on the rear panel of the server.
Step 2. Initiate a console session, and access the
MP Main Menu.
Step 3. Enter CM to enable command mode.
Step 4. Enter PC to use the remote power control command.
Step 5. Enter ON to power on the server, and enter YES when prompted to confirm the action.
Step 6. Start the operating system.
Powering On the Server Manually
NOTE If the power restore feature is set to Always On through the iLO MP PR command, the server
automatically powers on to the full power state when the power cord is plugged in to the server.
To manually power on the server, follow these steps:
Step 1. Plug all power cables into the receptacles on the rear panel of the server.
Step 2. Press the power button to start the server.
Step 3. Start the operating system.
Powering Off the Server
Power off the server using the following methods if the server is in the standby or full power state:
•iLO MP PC command
• Power button
Powering Off the Server Using the iLO MP PC Command
To power off the server using the iLO MP PC command, follow these steps: