Chapter 6
Removing and Replacing Components
Removing and Replacing the iLO MP Card
210
Step 4. Unscrew the two mounting screws that connect the iLO MP card to the internal chassis post and
the two external mounting screws that are located on both sides of the 25-pin serial connector.
Figure 6-61 Removing the iLO MP card
Step 5. Disconnect the iLO MP card connector.
Step 6. Remove the iLO MP card from the server by grasping it by its edges (Figure 6-61).
Replacing the iLO MP card
Step 1. Insert the iLO MP card in the server by grasping its edges and placing it on the two iLO MP card
posts.
Step 2. Push the 10/100 management LAN, 15-pin VGA and 25-pin serial connectors through their
openings on the back of the server.
Step 3. Connect the iLO MP card:
• Connect the iLO MP card cable to its connector on the system board
• Insert and tighten the two mounting screws that connect the iLO MP card to the internal
chassis post
• Insert and tighten the two external mounting screws that are located on both sides of the
25-pin serial connector
Step 4. Replace the top cover.
Step 5. Reconnect power and external cables. (Do not turn on the server at this time.)
To Next Page
Loading...
