HP 9000 rp3410 - Figure 6-71 Replacing Mechanical Covers; Figure 6-72 Reinstalling the Power Connectors

Chapter 6
Removing and Replacing Components
Removing and Replacing the System Board
219
Step 6. Replace the mechanical covers over the VGA and DB9 ports.
Figure 6-71 Replacing Mechanical Covers
Step 7. Replace the power connectors in their slots on the back of the server and screw in the power
connector mounting screws.
Figure 6-72 Reinstalling the Power Connectors
Step 8. Replace the following server components:
• iLO MP card. (See “Replacing the iLO MP card” on page 210)
• Dual processor modules. (See “Installing a Dual Processor Module” on page 190)
• Memory DIMMs. (See “Installing System Memory” on page 181)
• Processor airflow guide. (See “Replacing the Processor Airflow Guide” on page 175)
• Memory airflow guide. (See “Replacing the Memory Airflow Guide” on page 172)
• PCI card cage. (See “Removing the PCI Card Cage” on page 200)
• System fans. (See “Replacing a System Fan” on page 163)