HP 9000 rp3410 - Replacing the Ilo MP Card Battery; Figure 6-62 Removing the Ilo MP Card Battery

Chapter 6
Removing and Replacing Components
Removing and Replacing the iLO MP Card Battery
212
CAUTION Only lift the battery high enough to clear the holder. Excessive stress on the battery
holder retaining clip can damage the clip.
Figure 6-62 Removing the iLO MP Card Battery
Replacing the iLO MP Card Battery
Step 1. Lift up on the battery holder retaining clip with a flat-head screwdriver and slide the battery into
the holder. The positive (+) terminal of the battery faces up.
CAUTION Only lift the battery high enough to clear the holder. Excessive stress on the battery
holder retaining clip can damage the clip.
Step 2. Replace the iLO MP card. (See “Replacing the iLO MP card” on page 210.)
Step 3. Verify the battery replacement and operation by using the system utilities. (See the Utilities
chapter or the HP Integrity and HP 9000 iLO MP Operations Guide for additional information.)
• Use the iLO MP commands to verify operation.
• Use the BCH commands to verify operation.