HP 9000 rp3410 - Removing and Replacing System Fans; Removing a System Fan; Figure 6-15 Aligning the Pedestal Front Bezel

Chapter 6
Removing and Replacing Components
Removing and Replacing System Fans
161
Replacing the Front Bezel on a Pedestal-Mounted Server
To replace the front bezel, follow these steps:
Step 1. Position the bezel at an approximate 45 degree angle and align the retaining slots at the bottom
with the retaining tabs on the chassis. Press the bezel against the chassis to engage the tabs.
Figure 6-15 Aligning the Pedestal Front Bezel
Step 2. Rotate the bezel against the chassis so that it snaps into place.
Removing and Replacing System Fans
There are four system fans to keep the server cool when it is running. The system fans are hot-swappable,
enabling you to replace a fan while the server is running.
CAUTION When the server is running, the top cover must be replaced within five minutes to prevent
components from overheating.
Removing a System Fan
Step 1. Remove the top cover. (See “Removing and Replacing Server Covers and Bezel” on page 151.)
Step 2. Remove the fan.