Chapter 6
Removing and Replacing Components
Removing and Replacing the Hard Disk Drive (SCSI) Backplane
230
Replacing the Hard Disk Drive SCSI Backplane
Step 1. Insert the hard drive backplane onto its four chassis standoffs and slide it to the left as you face it.
This locks the hard drive backplane in place.
Step 2. Screw in the two backplane mounting screws and connect the two SCSI cables.
Step 3. Connect the backplane power cable and lower the fan power bridge until it snaps in place.
Step 4. Replace fans 2 and 3. (See “Removing and Replacing System Fans” on page 161.)
Step 5. Replace the PCI card cage. (See “Replacing the PCI Card Cage” on page 202.)
Step 6. Replace the top cover.
Step 7. Reconnect all power and external cables.
Step 8. Verify the backplane replacement and operation by using the system utilities. (See the Utilities
chapter or the HP Integrity and HP 9000 iLO MP Operations Guide for additional information.)
• Use the iLO MP commands to verify operation.
• Use the BCH commands to verify operation.
To Next Page
Loading...
