Chapter 3
55
3 Installing the System
This chapter provides information on how to install the system.
This chapter addresses the following topics:
• “Introduction” on page 55
• “Unpacking and Inspecting the Server” on page 61
• “Installing Additional Components” on page 63
• “Installing the Server Into a Rack, Non-HP Rack, or Pedestal” on page 104
• “Connecting the Cables” on page 105
• “Console Setup” on page 107
• “Accessing the Host Console” on page 116
• “Powering the Server ON and OFF” on page 118
• “Booting the Operating System” on page 120
• “Troubleshooting” on page 123
Introduction
The HP 9000 rp3410 server is a 1P/1C, 1P/2C, rack- or pedestal-mount server. Similarly, the HP 9000 rp3440
server is a 1P/1C, 1P/2C, or 2P/2C, rack- or pedestal-mount server. Both of these servers are based on the
PA-RISC processor family architecture. The server accommodates up to 12 DIMMs and internal peripherals
including disks and DVD. Its high availability features include hot-swappable power supplies and
hot-pluggable disk drives. The supported operating system is HP-UX 11i v1 (and newer HP-UX versions that
support PA-RISC systems).
To Next Page
Loading...
