Installing the System
Installing Additional Components
Chapter 3
93
Figure 3-36 Replacing the Power Supply
Step 4. Push in on the power supply release lever to lock the retaining clip in place.
Step 5. Replace the front bezel. (See “Removing and Replacing Front Bezel on a Pedestal-Mounted Server”
on page 71.)
Step 6. Verify that both power supply LEDs are lit.
Step 7. Use the iLO MP PS command to verify power supply operation.
Installing an Additional Processor Module
This section provides information about installing dual processor modules. The modules are located on the
system board which is accessible by removing the server cover.
The HP 9000 rp3410 server supports one processor socket. This socket will accept one dual processor module
which contains two 800 MHz CPUs. The HP 9000 rp3410 server 1P/1C configuration includes two CPUs in a
single module, but only one CPU is enabled. (The second CPU can be enabled as part of a server upgrade.)
The HP 9000 rp3440 server supports two processor sockets. Each socket will accept one dual processor
module which contains either two 800 MHz CPUs or two 1 GHz CPUs.
WARNING Ensure that the server is powered off and all power sources have been disconnected
from the server before removing or replacing a dual processor module.
Voltages are present at various locations within the server whenever an ac power
source is connected. This voltage is present even when the main power switch is in
the off position.
Failure to observe this warning can result in personal injury or damage to
equipment.
Power Supply 1
Power Supply
To Next Page
Loading...
