HP 9000 rp3410 - Figure 6-39 Disconnect the Turbo Fan Cable; Figure 6-40 Release Heatsink Captive Screws

Chapter 6
Removing and Replacing Components
Removing and Replacing a Dual Processor Module
187
Step 9. Disconnect the turbo fan power cable.
Figure 6-39 Disconnect the Turbo Fan Cable
Step 10. Release the four heatsink captive screws on the module heat sink.
Figure 6-40 Release Heatsink Captive Screws
Step 11. Slide the sequencing retainer plate toward the back of the server to open the hole in the edge of the
heatsink for insertion of the special processor tool into the processor module locking mechanism.
CPU Install Tool