HP 9000 rp3410 - Accessing Pedestal-Mount Server; Figure 6-8 Replacing the Front Bezel on a Rack-Mounted Server

Chapter 6
Removing and Replacing Components
Removing and Replacing Server Covers and Bezel
156
Step 2. Close the bezel and push toward the front of the server until it locks into place.
Figure 6-8 Replacing the Front Bezel on a Rack-Mounted Server
Accessing Pedestal-Mount Server
Both the HP 9000 rp3410 and the rp3440 servers are available in a pedestal configuration or can be converted
from a rack to a pedestal configuration. To access the internal components on a pedestal server, you must
remove the side and top covers.
Removing the Side Covers on a Pedestal-Mounted Server
NOTE If you are replacing a hot-swappable item, you can leave the server on and external cables
(including the power cord) connected.
Step 1. Power off the server and disconnect the power and external cables.
Step 2. Remove the side cover.
a. Grasp both indentations at the top of the side panel and pull outward.