HP 9000 rp3410 - Figure 3-8 Closing the Top Cover; Figure 3-9 Front Bezel Retaining Clip

Installing the System
Installing Additional Components
Chapter 3
66
Step 2. Grasp the blue release lever and slide the cover toward the front of the server until the lever snaps
into place.
Figure 3-8 Closing the Top Cover
Step 3. Slide the server into the rack enclosure and reconnect the power and external cables.
Removing and Replacing the Front Bezel on a Rack-Mounted Server
You must remove the front bezel from the chassis to gain access to the power supplies and optical drive.
Removing the Front Bezel on a Rack-Mounted Server
Step 1. Press in on the retaining clips located on the right-side of the front panel.
Figure 3-9 Front Bezel Retaining Clip