HP xw4600 User Manual

Screen message Probable cause Recommended action
4. Replace diskette drive.
5. Replace the system board.
605—Diskette Drive Type
Error
Mismatch in drive type. 1. Run the Computer Setup (F10) Utility.
2. Disconnect any other diskette controller devices
(tape drives).
3. Clear CMOS.
912—Computer Cover Has
Been Removed Since Last
System Start Up
N/A No action required.
914— Coil is not Connected Mechanism is missing or not
connected.
1. Reconnect or replace ing mechanism.
2. Reseat or replace ing mechanism cable.
916—Power Button Not
Connected
The power button is not connected. Connect power button.
917—Front Audio Not
Connected
The front audio cable is not connected. Connect front audio cable.
918—Front USB Not
Connected
Front USB is not connected. Connect front USB cable.
960—CPU Overtemp
occurred
The ambient temperature could
exceed operating limits
(maximum=95F), or there are
obstructions to airflow, including dust
buildup.
1. Be sure you are not operating the system in an
environment that exceeds 95F.
2. Disconnect power and open the access panel.
3. Verify that cables are not blocking processor
heatsink fans or front fan (if installed).
4. Verify that there is not excessive dust on major
components.
5. If airflow is acceptable and there is not excessive
dust, the thermal sensing circuitry has failed on the
processors or on the system board. You must
replace the processors and/or the system board.
1720—SMART Hard Drive
Detect Imminent Failure
Hard drive is about to fail. (Some hard
drives have a firmware patch that fixes
erroneous error messages.)
1. Determine if hard drive is giving correct error
message.
2. Run the Drive Protection System test (if
applicable).
3. Apply firmware patch (if applicable).
See
http://www.hp.com/support.
4. Back up contents and replace the hard drive.
1780—Disk 0 Failure The drive is not installed correctly or
has failed.
1. Be sure that any jumpers are set correctly, and
that power and drive cables are connected, both
to the drive and the system board.
2. Verify that the cables are the correct cables for
your computer model. If this message persists,
your workstation might require service.
Table 5-18 POST error messages (continued)
138 Chapter 5 System diagnostics and troubleshooting ENWW

HP xw4600 Specifications

General

Tcase	72.4 °C
Bus type	FSB
Stepping	E0
Processor cache	6 MB
Processor cores	2
Processor model	E8400
System bus rate	- GT/s
Processor family	Intel® Core™2 Duo
Processor series	Intel Core 2 Duo E8000 Series
Processor socket	LGA 775 (Socket T)
Processor codename	Wolfdale
Processing Die size	107 mm²
Processor frequency	3 GHz
Processor cache type	L2
Processor lithography	45 nm
Processor manufacturer	Intel
Processor front side bus	1333 MHz
Processor operating modes	64-bit
ECC supported by processor	No
Thermal Design Power (TDP)	65 W
Number of processors installed	1
CPU multiplier (bus/core ratio)	9
Number of Processing Die Transistors	410 M
Audio system	High Definition Audio
Product type	Workstation
Motherboard chipset	Intel® X38 Express
ECC	Yes
Internal memory	2 GB
Memory clock speed	800 MHz
Internal memory type	DDR2-SDRAM
Maximum internal memory	8 GB
Memory layout (slots x size)	2 x 1 GB
HDD speed	7200 RPM
HDD capacity	250 GB
HDD interface	SATA
Optical drive type	DVD-RW
Graphics card	-
Networking features	Gigabit Ethernet (10/100/1000)
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Power supply	475 W
Chassis type	Tower
Country of origin	China
Processor code	SLB9J
Processor ARK ID	33910
Processor package size	37.5 x 37.5 mm
On-board graphics card model	Not available

Weight and Dimensions

Depth	456 mm
Width	168 mm
Height	450 mm
Weight	19000 g