218
Figure 10 Configuring the system settings of the ACS
6. Add configuration templates and software library entries for the two classes of devices:
a. Select Service > BIMS > Configuration Management > Configuration Templates from
the navigation tree.
Figure 11 Configuring templates page
b. On the Configuration Templates page, click Import….
c. On the Import Configuration Template page, select configuration template settings for the
Device_A device class, add the Device_A class to the Applicable CPEs pane, and then
click OK.
d. Repeat the previous two steps to configure a configuration template for equipment room B's
device class.
To Next Page
Loading...
