Huawei NetCol5000-A025 - Page 127

Paramete
r
Description Conguration
Principle
Default Value
Cascade After the requirement
control is enabled, you
can congure
Cascade. The cascade
function starts
standby smart cooling
products if the active
one cannot meet the
refrigerating
requirements.
If the heat load to the
device increases, the
cascade function is
recommended.
Disable
Large ring
cooling
capacity P
Proportion coecient
in L1/L2 linkage PID
control.
You are not
recommended to
change the value.
0.10
Large ring
cooling
capacity I
Integration coecient
in L1/L2 linkage PID
control.
You are not
recommended to
change the value.
350s
Large ring
cooling
capacity D
Dierential coecient
in L1/L2 linkage PID
control.
You are not
recommended to
change the value.
10s
Cooling
capacity
adjustmen
t period
Adjustment period in
L1/L2 linkage PID
control.
You are not
recommended to
change the value.
5s
L1/L2
linkage
cooling
stop ref.
temp
Reference
temperature at which
the smart cooling
product stops cooling
in the cooling mode in
L1/L2 linkage.
Set this parameter
based on the lowest
temperature allowed
onsite. Normally you
are not recommended
to change the value.
18.0°C
L1/L2
linkage
dehumid
stop ref.
temp
Reference
temperature at which
the smart cooling
product stops
dehumidication in
the
dehumidication
mode in L1/L2
linkage.
Set this parameter
based on the lowest
temperature allowed
onsite. Normally you
are not recommended
to change the value.
18.0°C
L1/L2
linkage
cooling
stop delay
Duration within which
the device is still
cooling when the
cooling stop condition
is met in L1/L2
linkage.
Set this parameter
based on the lowest
temperature allowed
onsite. Normally you
are not recommended
to change the value.
180s
NetCol5000-A025 In-row Air Cooled Smart Cooling
Product
User Manual (300 mm Width) 4 Power-On Commissioning
Issue 15 (2020-12-10) Copyright © Huawei Technologies Co., Ltd. 117