Huawei NetCol5000-A025 - Setting Communications Parameters; Setting Communications Parameters (Modbus RTU Protocol)

NO TE
If teamwork succeeds, the teamwork icon is green. If teamwork fails, the teamwork icon is
red. If teamwork mode is disabled, the teamwork icon is gray.
----End
Follow-up Procedure
After you have completed the settings, perform the following checks to conrm
whether the teamwork control is available:
1. Check whether the device number on the topology is the same as the actual
device number.
– If yes, go to 2.
– If no, check the cable connection and the settings of teamwork control
parameters.
2. Check whether the number of the active devices on the topology is the same
as the actual device number.
– If yes, go to 3.
– If no, check the cable connection and the settings of teamwork control
parameters.
3. Check whether the number of standby devices on the topology is the same as
the actual device number.
– If yes, go to 4.
– If no, check the cable connection and the settings of teamwork control
parameters.
4. Check whether the number of online devices on the topology is the same as
the actual device number.
– If yes, the check is complete.
– If no, check the cable connection and the settings of teamwork control
parameters.
4.4.3.3 Setting Communications Parameters
4.4.3.3.1 Setting Communications Parameters (Modbus RTU Protocol)
Procedure
Step 1 On the home screen, choose Settings > Comm Settings > Modbus Settings.
NetCol5000-A025 In-row Air Cooled Smart Cooling
Product
User Manual (300 mm Width) 4 Power-On Commissioning
Issue 15 (2020-12-10) Copyright © Huawei Technologies Co., Ltd. 120