Huawei NetCol5000-A025 - (Optional) Connecting the Humidifier Water Inlet Pipe

Figure 3-37 Connecting the drainpipe in the scenario of top pipe routing
3.10.3 (Optional) Connecting the Humidier Water Inlet Pipe
There are wet lm and electrode humidiers. Select either as required.
A
humidier water inlet pipe can be routed from the bottom or top. You can route
the pipe based on site requirements.
NO TICE
● When routing pipes from the top, do not route the pipes over servers. If
unavoidable, take measures to protect the servers from being
aected by pipe
leaking.
● Do not remove the humidier water inlet pipe to prevent sealing failure
between the water inlet pipe and the
humidier cylinder.
3.10.3.1 (Optional) Connect the Water Inlet Pipe to the Electrode Humidier
The humidier water inlet pipe is a hose installed under the humidier. When
connecting the hose, straighten the hose, as shown by Figure 3-38 and Figure
3-39.
NetCol5000-A025 In-row Air Cooled Smart Cooling
Product
User Manual (300 mm Width) 3 Installation Guide
Issue 15 (2020-12-10) Copyright © Huawei Technologies Co., Ltd. 67