Procedure
Step 1 On the home screen, choose Maint > Sensor Calibration.
Step 2 Fill the calibration value based on the measured error.
----End
7.1.13 Calibrating the Screen
Context
● You can calibrate for touching point deviation on the touchscreen.
● You can calibrate the screen by tapping the screen on the Screen Calibration
page or by DIP switch.
– Tapping the screen on the Screen Calibration page: The program of the
display board works normally; the deviation between the touching point
and the responding point is small; the Maint > Screen Calibration page
can be entered over the screen.
– Calibrating the screen by DIP switch: The display board works normally;
the deviation between the touching point and the responding point is
unfavorably big; or the screen does not respond when being tapped.
● You can calibrate the screen by DIP switch only when the system enters Quick
Settings page after the
rst power-on or when the system is on the home
screen.
● Touch the display screen
rmly if you are using your ngertips. It is
recommended that you use the pen tip for accurate selection and quick
response.
Procedure
● When calibrating the screen by tapping the screen, tap Maint > Screen
Calibration, as shown in Figure 7-12. Figure 7-13 is displayed when the
screen calibration is complete.
NetCol5000-A025 In-row Air Cooled Smart Cooling
Product
User Manual (300 mm Width) 7 FAQ
Issue 15 (2020-12-10) Copyright © Huawei Technologies Co., Ltd. 275
To Next Page
Loading...
