Icom IC-705 - Message Operation; Dentering a TX Message; Dtransmitting a Message; Ddeleting a TX Message

14-11
14. D-STAR OPERATION (ADVANCED)
Message operation
You can save up to 5 short messages in the
transceiver’s memory to transmit in the DV mode.
Each message can be up to 20 characters.
DEntering a TX message
Example: Entering “JAPAN TOM” into TX
message memory number 1.
1. Open the TX MESSAGE screen.
»
SET > My Station > TX Message
2. Touch a TX message memory number for 1
second.
3. Touch “Edit.”
4. Enter a message of up to 20 characters, then
touch [ENT].
5. To close the TX MESSAGE screen, push .
DTransmitting a message
You can transmit a preset TX message by
pushing [PTT] in the DV mode. First, select a
TX message which also turns ON the Message
Transmission function.
1. Open the TX MESSAGE screen.
»
SET > My Station > TX Message
2. Touch a TX message memory number.
LTo not transmit any message, touch “OFF.”
3. To close the TX MESSAGE screen, push .
LInformation
• The message is transmitted with your voice signal.
• The message is transmitted each time you transmit.
• When continuously transmitting, the selected TX
message is transmitted every 30 seconds.
DDeleting a TX message
You can delete the TX messages.
Example: Deleting TX message “JAPAN TOM”
from TX message memory number 1.
1. Open the TX MESSAGE screen.
»
SET > My Station > TX Message
2. Touch a TX message memory number for 1
second.
3. Touch “Clear.”
• The confirmation dialog is displayed.
4. Touch [YES].
• Clears the entered message.
5. To close the TX MESSAGE screen, push .