14-36
14. D-STAR OPERATION (ADVANCED)
Are your settings correct?
If you make a Local Area call with a gateway repeater still selected in “TO,” the destination repeater will
be busy while you transmit. The stations that want to use the repeater as their Access repeater cannot
access it, as shown below.
BE SURE to set CQCQCQ in “TO” on the DR screen when you intend to make a Local Area call, or after
you finish a Gateway call.
Example: JA3YUA wants to make a Local Area call.
NOTE: With this setting, you can make a Local
Area call, but the destination Repeater, selected
in “TO,” is also busy while you transmit.
The stations that want to use the repeater as
their Access Repeater cannot access it.
JA3YUA’s setting
The destination (“TO”) setting is incorrect.
Correct setting
To make a Local Area call, set the destination (“TO”)
to “CQCQCQ.” See page 14-7 for details.
CQ D-STAR Hirano, this is JA3YUA
through JP3YHH port A for a local call...
CQ D-STAR Hirano, this is JA3YUA
through JP3YHH port A for a local call...
CQ D-STAR Hirano, this is
JA3YUA through JP3YHH port A
for a local call...
CQ D-STAR Hirano, this is
JA3YUA through JP3YHH port A
for a local call...
CQ D-STAR Hirano, this is
JA3YUA through JP3YHH port A
for a local call...
CQ D-STAR Hirano, this is
JA3YUA through JP3YHH port A
for a local call...
INTERNETINTERNET
His setting is wrong!
I can’t access the repeater!
His setting is wrong!
I can’t access the repeater!
Hirano area Kirkland area
Hirano repeater Kirkland repeater
To Next Page
Loading...
