11-2
11. WIRELESS LAN OPERATION
Connecting to a Wireless Access Point (AP)
1. Open the ACCESS POINT screen.
»
SET > WLAN Set > Connection Settings
> Access Point
2. Touch a wireless access point (AP).
(Example: WIRELESSLAN)
3. Touch “Password.”
4. Enter the password, and then touch [ENT].
(Example: password)
5. Touch “<<Connect>>.”
• Connects to the AP.
• While connected to the AP, “Connected” is
displayed in the ACCESS POINT list.
LIf the connection fails, returns to the CONNECT
screen.
6. To close the ACCESS POINT screen, push
several times.
LWhile connected to a wireless network, the
wireless LAN icon is displayed.
Displayed
LThe transceiver automatically connects to the
last connected AP when the transceiver is
turned ON.
NOTE:
• The transceiver cannot connect to a 5 GHz
wireless network.
• Up to 7 access points that the transceiver has
connected to before are saved. When you connect
to the 8th AP, the oldest AP is deleted.
• It may take a longer time to turn OFF the
transceiver while connected to the AP, depending
on your network environment.
TIP:
Search again for an Access Point device
When the transceiver cannot find an AP that
you want to connect to, push
, and then
touch “Re-search” to search again.
Manually connect to an Access Point device
1. Open the MANUAL CONNECT” screen.
»
SET > WLAN Set > Connection Settings
> Manual Connect
2. Set “SSID,” “Security Type,” and “Password.”
3. Touch “<<Connect>>.”
To Next Page
Loading...
