8-5
8. SCANS
Entering Scan Edges
You can enter the upper and lower frequency
edges to the Program Scan Edge ranges for
Program scans. Each Program Scan Edge range
has its own name, mode, and IF filter settings.
You can enter a total of up to 25 Program Scan
Edge ranges.
LThe default setting may differ, depending on the
transceiver’s version.
1. Display the SCAN SET screen.
»
SCAN > SET
2. Touch “Program Scan Edge.”
3. Touch the channel that you want to enter, for
1 second. (Example: 00)
4. Touch “Edit.”
5. Touch “NAME.”
6. Enter a name, then touch [ENT].
7. Touch “FREQUENCY.”
8. Enter the upper and lower edge frequency,
then touch [ENT].
Entry example:
[1] [1] [8] [ENT] [1] [3] [6] [ENT]
LTouch to select the upper and lower edge
frequency, and then rotate or touch the
keypad to edit the frequency.
9. Touch “MODE.”
10. Touch the mode to be used during a scan.
(Example: AM)
LWhen you select “---,” the mode set in the VFO
mode is used during a scan.
LWhen you select “WFM,” you cannot select “FIL.”
11. Touch “FIL.”
12. Touch the IF filter number to be used during a
scan. (Example: FIL 1)
13. Touch “<<Write>>.”
14. Touch [YES].
• A beep sounds, and the Program Scan Edge
ranges are entered.
• Returns to the PROGRAM SCAN EDGE screen.
To Next Page
Loading...
