8-3
8. SCANS
SCAN SET screen
1. Display the SCAN screen.
»
SCAN
2. Touch [SET].
3. Touch the item to set.
(Example: SCAN Speed)
4. Touch the option to set. (Example: Slow)
5. To close the SCAN SET screen, push .
TIP: You can set each item to its default by
touching the item for 1 second, and then
touching “Default” on the QUICK MENU screen.
SCAN Speed (Default: Fast)
Sets the desired scan speed to slow or fast.
• Slow: Scan speed is slow.
• Fast: Scan speed is fast.
SCAN Resume (Default: ON)
Sets the Scan Resume function to ON or OFF.
• OFF:
When a signal is detected, cancels the scan.
• ON: When a signal is detected, the scan
pauses for 10 seconds, then resumes.
Two seconds after the signal disappears,
the scan resumes.
Pause Timer (Default: 10sec)
When Scan Resume is ON, selects the Scan
Pause Timer. When receiving a signal, the scan
pauses for this set period of time.
• 2 ~ 20sec: When a signal is received, the scan
pauses for 2 ~ 20 seconds (in 2
second steps).
• HOLD: The scan pauses on a received
signal until the signal disappears.
Resume Timer (Default: 2sec)
Selects the scan Resume Timer. When a
received signal disappears, the scan resumes
after this set period of time passed.
• 0sec: The scan resumes immediately after
the signal disappears.
• 1 ~ 5sec: The scan resumes 1 ~ 5 seconds
after the signal disappears.
• HOLD: The scan remains paused for the
Pause Timer setting, even if the
signal disappears.
Temporary Skip Timer (Default: 5min)
Sets the Temporary Skip Timer. The unwanted
frequencies that are set as Skip channels (PSKIP
or SKIP) are skipped for this set period of time
during a scan.
LThis timer is activated for the VFO scan, Memory
scan, and DR scan.
• 5min/10min/15min: Skip channels are skipped
for the set period of time.
• While Scanning: Skip channels are skipped
until the scan is stopped.
• While Powered ON: Skip channels are skipped
until the transceiver is
turned OFF.
MAIN DIAL Operation (SCAN)
(Default: Up/Down)
Selects the function of
while scanning.
• OFF: Rotating
stops the scan.
• Up/Down: Rotating
changes the
scanning direction.
Program Scan Edge
You can delete, copy, or edit the lower and higher
frequencies for programmed scans.
The transceiver has a total of up to 25 frequency
ranges (00 ~ 24), and you can set the scan
name, mode, and the IF filter for each Scan
Edge.
LThe default setting may differ, depending on the
transceiver version.
LSee page 8-5 for entering Scan Edges.
To Next Page
Loading...
