Icom IC-705 - Pairing with an Android Device

10-5
10.
Bluetooth
®
OPERATION
Pairing with an Android™ device
Before connecting to an Android™ device, you
must pair with it.
This section describes how to pair with an
Android device.
See page 14-37 about connecting to the
transceiver with an Android device using the
RS-MS1A application.
NOTE: Depending on the Bluetooth device, you
may not be able to pair with it.
Step 1� Entering the Pairing Reception mode
(Transceiver)
1. Open the BLUETOOTH SET screen.
»
SET > Bluetooth Set
2. Touch “<<Pairing Reception>>.”
Turn ON Bluetooth with your Android device
within the displayed period of time.
When the time runs out, the transceiver exits
the Pairing Reception mode.
Step 2� Turning ON Bluetooth
(Android device)
Turn ON Bluetooth with your Android device.
• The Android device displays the transceiver
Bluetooth unit’s name.
LYou can confirm the transceiver Bluetooth unit’s
name on the BLUETOOTH DEVICE INFORMATION
screen. (Default: ICOM BT(IC-705)) (p. 10-7)
LSee the instruction manual of the Android device for
details.
Step 3� Sending a pairing request to
the transceiver (Android device)
Select the displayed transceiver Bluetooth unit’s
name to send a pairing request to.
• The Android device starts to send a pairing request.
• The Android device displays “To pair with: ICOM
BT(IC-705). Make sure it is showing this passkey:
MMMMM.”
Step 4� Receiving a pairing request
(Transceiver)
1. When the transceiver receives a pairing
request, confirm the displayed passkey is the
same as yours, and then, touch [CONFIRM].
• Pairing starts.
2. Touch “Pairing/Connect.”
After the pairing is complete, the
Android device name is displayed on
the pairing list.
NOTE: When you pair with a third party’s data
device, entering a PIN code or passkey may be
required. See the instruction manual of the data
device for details on how to enter a PIN code or
passkey.