14-24
14. D-STAR OPERATION (ADVANCED)
Entering new information into the repeater list
This section describes how to manually enter
new repeater information into the repeater list.
The required setting items differ, depending on
your communication usage. Confirm the required
items, as shown below.
NOTE: To enter repeater information into the
repeater list, the repeater’s call sign must be
entered first.
DRequired items for the communication cases
Repeater list
contents
Used as an
access repeater
Used as a
destination
repeater
Used as an FM
repeater
Simplex (FROM)
TYPE DV Repeater DV Repeater FM Repeater DV Simplex FM Simplex
NAME
SUB NAME
CALL SIGN
� �
N/A N/A
GW CALL SIGN
�
(For a Gateway call)
�
N/A N/A N/A
GROUP
USE(FROM)
� � � �
FREQUENCY
� � � �
DUP
� �
N/A N/A
OFFSET FREQ
� �
N/A N/A
TONE N/A N/A
N/A
REPEATER
TONE
N/A N/A
N/A
POSITION
LATITUDE
LONGITUDE
UTC OFFSET
�: Must be entered
: Possible to enter
N/A: Not Applicable
To Next Page
Loading...
