15-16
15. ABOUT THE DV GATEWAY FUNCTION
Access Point mode operation
DSetting the Access Point mode
In this section, set an Access Point transceiver.
1. Open the DV GATEWAY screen.
»
2 > DV GW
2.
T
ouch “<<Access Point Mode>>.”
3. Rotate to set the operating frequency.
LThe frequency is used to communicate with the
Remote D-STAR transceiver.
LIn the Access Point mode, you can change the
operating frequency.
Internal Gateway icon
“Ext” is displayed when using the
External Gateway function.
NOTE: BE SURE to check your local regulations or
laws to select the appropriate operating frequency.
When using the External Gateway function
After the transceiver is in the Access Point mode,
click (touch) <Start>
in the RS-MS3W or
RS-MS3A.
LIf an error message is displayed, see page 15-26 for
tips on how to solve the problem.
NOTE: In the Access Point mode
• The Power Save function is not activated.
• The following items are automatically set.
Mode: VFO mode*
Operating mode: DV mode*
Duplex mode: OFF*
RIT function: OFF
VOX function: OFF
MONITOR function: OFF
*
These settings do not return to the previous
settings, even if you cancel the Access Point mode.
• The Access Point mode is not automatically
canceled, even if you turn OFF the transceiver,
then turn it ON again.
TIP: Canceling the Access Point mode
Touch “<<Normal Mode>>” in the DV
GATEWAY screen.
»
2 > DV GW > <<Normal Mode>>
LWhen using the External Gateway function, click
(touch) <Stop>
in the RS-MS3W or RS-MS3A
before the transceiver returns to the normal mode.
About the Internal Gateway icon
When using the Internal Gateway function,
displays the communication status.
Icon Status
In the standby mode
While transmitting
While receiving
Transmission error (The repeater is busy.)
Transmission error
Network error
Receiving while transmitting
Receive error
LIf an error icon is displayed, see page 15-21 to
read the tips to solve the problem.
To Next Page
Loading...
