14-35
14. D-STAR OPERATION (ADVANCED)
Manually setting Call Signs
Set or view the “UR,” “R1,” “R2,” and “MY” call
signs to use in the DV mode.
»
2 > CS
When not using the DR function, sets the call
signs on this screen.
For Simplex operation (DV mode)
You can set the “UR” and “MY” call signs.
For Duplex (repeater) operation
(DV mode/DR function)
You can set only the “MY” call sign when the DR
function is ON.
<To manually set the Duplex (repeater) operation>
Example: Making a gateway CQ call to Kirkland
repeater (N71H B) from the Hirano
repeater (JP3YHH A), in the DV mode.
Destination call sign
Repeater call sign
Gateway repeater call sign
Your call sign
LBefore starting to set the call sign, set the frequency
of your Access repeater and duplex direction on the
standby screen.
TIP: When the Digital Repeater Set function is
ON, the repeater call sign is automatically set.
»
SET > DV Set > Digital Repeater Set
Step 1� Setting the call sign “R1”
1. Touch “R1” for 1 second.
2. Touch “Edit.”
3. Enter the repeater call sign of up to 8
characters, including spaces.
(Example: JP3YHH A)
4. Touch [ENT].
• Sets the entered repeater call sign.
Step 2� Gateway “R2” setting
1. Touch “R2.”
LTo manually enter a call sign, touch “R2” for 1
second, then touch “Edit.”
2. Touch “GW.”
About the RPT2 SELECT screen
NOT USED* For local area calls
GW
To select the gateway call sign from the
repeater list.
Repeater name
To select the repeater that has the
same gateway as the “R1” repeater.
Step 3� Destination “UR” setting
1. Touch “UR.”
LTo manually enter a call sign, touch “UR” for 1
second, then touch “Edit.”
2. Touch “Gateway CQ.”
3. Touch repeater group where your destination
repeater is listed.
4. Touch a destination repeater.
About the YOUR SELECT screen
CQCQCQ
To select “CQCQCQ” to make a non-
call sign specific call.
Gateway CQ*
To select “Gateway CQ” to make a call
using the repeater list.
Your Call Sign
To select the destination “UR” call sign
using the Your Call Sign memory.
RX History
To select the destination “UR” call sign
using RX History.
TX History
To select the destination “UR” call sign
using TX History.
* Not displayed in the Simplex mode.
To Next Page
Loading...
Need help?
General
