15 Decommissioning - demolition
BIESSE S.p.A. © - p727k0001.fm251111
115
15 Decommissioning - demolition
During the machine's life cycle it may be necessary to transfer it to another location. In this event,
proceed as follows.
1. Turn the machine off, disconnect it from the power supply.
2. Remove and put away all the tools still fitted in the machine.
3. Clean the machine and protect all parts subject to corrosion using suitable products.
4. For transport and installation of the machine in its new location, use the methods and
equipment described in this manual.
The machine uses lubricating oil and grease. To neutralise the lubricant fluids which remain
attached to parts of the machine and cannot be reused, use degradable solvents of an approved
type. For evacuation of recoverable lubricant fluids empty the tanks and deliver the fluids to the
local authority in charge of disposal. Any glass waste, batteries, accumulators, buffer batteries for
electronic cards and conditioners that may be found in the machine must also be disposed of in a
suitable manner.
When the machine reaches the end of its technical working life it must be totally decommissioned
so that it can no longer be used for the purposes for which it was designed and built. If any parts
are used again it must be for purposes other than those for which the individual part and the
machine as a whole was originally designed and constructed.
BIESSE declines all liability for damage to persons of things that may derive from any secondary
use of single parts of the machine for functions or assemblies other than those originally
contemplated. BIESSE recognises no implicit or explicit suitability for specific purposes of any
parts of the machine which are used again after final decommissioning in view of demolition.
To Next Page
Loading...