9 Basic use
BIESSE S.p.A. © - p711k0005.fm251111
57
9 Basic use
9.1 Machine start-up
To turn the machine on, carry out the following procedure:
1. Check that all the emergency stop devices have been disabled.
2. Turn on the compressed air and machining water supplies.
3. Turn the main switch (on the back of the electric panel) to I (ON).
4. Turn the main switch of the UHP intensifier to I (ON).
5. Wait until the PC starts up.
6. Wait until the interface is enabled.
7. Switch on the processing centre by turning the key selector.
8. Check the mobile valve is up (raise it if necessary).
9. Perform the global reset of the axes:
- select the “RESET” icon
- activate the “GLOBAL RESET” flag
- press “START” to begin the reset
10. Wait until the axis and thickness tracer reset operation has been completed.
11. Wait until the “AXIS NOT CALIBRATED - RESET NEEDED” message disappears.
12. Position the piece on the work table, in the required work origin position.
13. Select the automatic mode.
14. Use the “OPEN” icon to open the work list.
15. Select the required work list, and press "confirm".
16. Select the required program and check that the "origin", "piece thickness", "quantity" and "stop
at cycle end" fields contain correct values.
17. Press the START station button for the work list to be executed.
To Next Page
Loading...