4 Intended use and unintended use
BIESSE S.p.A. © - p703k0003.fm251111
39
It can work sheets with the following maximum dimensions:
The machine cannot be configured to work any other materials than the ones listed
here.
4.3 Executable machining operations
The machine performs the following operations:
sectioning:
• full thickness
•partial
Pendular mode option
• To reduce working times with small pieces, the piece loading and unloading operations can
be carried out on one side of the table while the operating section is working on the other
side
X (mm) Y (mm) Z (mm)
Primus 184 2010 4200 250*
*
Refer to chapter 11 for the machining operation parameters.
Primus 322 3210 2000 250
Primus 324 3210 4000 250
To Next Page
Loading...