10 Carrying out machining operations
64
BIESSE S.p.A. © - p711k0006.fm251111
6. The selected program will be performed automatically.
7. Wait until the program has been completed.
8. Pick up the sheet (entering the working area, the safety guards are triggered; this disables the
power supply to the axis motors and discharges the pressure from the intensifier).
Pay attention while positioning the piece.
=Risk of crushed hands
For the next sheet, repeat the operations.
10.5 Using the machine in manual mode (axis
movement)
The machining operations are only performed in automatic mode, by executing a specific program.
The operator must know how to move the machine in manual mode however (both in continuous
mode and “step by step”, with incremental movements), in order to move the tool away from the
piece in the event of a stop or to acquire origin positions with the laser pointer or thickness tracer.
For the manual commands, refer to the User Interface Manual.
NB: it is possible to move the machine in manual mode by means of the special keys
(with prolonged pressure).
10.6 Using the machine in automatic mode
For information about the automatic mode, refer to the User Interface Manual.
10.7 Starting the machining operation
To start the machining operation, just press the Start button for the station (1 or 2) on which the
piece is positioned.
10.8 Working cycle
For the description of the working cycle, refer to the User Interface Manual.
To Next Page
Loading...