Intermac Primus 184 - 10.11 Interrupting the machining operation

10 Carrying out machining operations
66
BIESSE S.p.A. © - p711k0006.fm251111
10.11 Interrupting the machining operation
To interrupt the machining operation while the axes are moving (either single or with interpolation),
press the STOP button .
The machine will temporarily halt its movement, without altering the path set in the program (“Hold”
situation).
By pressing START , the machine resumes its movement.
If the safety devices have been activated with the hold status, make sure there is nobody in
the working area, then reactivate the safety guards before pressing START.