ASSEMBLY (See Figure 4D-1)
NOTE
During reassembly be sure all the parts are clean
and free of dirt.
1. Start one bushing in yoke ear and position center
cross through yoke.
2. Drive the first bushing flush with outside surface
of ear.
NOTE
Do not bend ear of yoke.
3. Support the ear and using a socket or mandrel
the same diameter as the bushing, drive the bush-
ing slightly past the snap ring groove.
4. Install the snap ring.
5. Repeat Steps 3 and 4 for the other bushings.
6. After assembly, ensure proper seating by striking
the forged surfaces of the yoke ear one sharp
blow with a soft mallet.
7. Lubricate the joint as described in Section 11.
8. Install assembly in tractor.
9. Adjust parking brake pad calipers (see Section 5C).
DRIVE TRAIN
SECTION 4D. AXLE DRIVE U-JOINT
4D-2
To Next Page
Loading...
Need help?
General
