DISASSEMBLY
(See Figures 6C-2 through 6C-6)
NOTE
Before disassembly, scribe a line from top to bot-
tom of steering unit housing. This line can be
used to determine proper orientation of sections
for assembly (see Figure 6C-13).
1. Securely place the power steering fixture in a vise.
2. Remove end cover screws (1) and washers (2).
NOTE
There are seven screws, one is a special screw
— note its position.
3. Slide cover (3) sideways from gear wheel set (4).
4. Lift gear wheel set (4) off housing.
5. Remove cardan shaft (9) and distributor plate (7).
6. Remove O-rings (5, 6 and 8).
(See Figure 6C-3)
7. Remove threaded bushing (10).
8. To remove check ball (11), two suction valve pins
(12) and two 13/16" check valve balls (13), turn
steering unit over.
STEERING
SECTION 6C. STEERING UNIT
6C-2
Figure 6C-2.
Figure 6C-3.
To Next Page
Loading...
Need help?
General
