13 Configuration
184
13.17 Counters/Integrators
27 counters/integrators are available and can be configured as counters, integrators, and op-
erating time counters:
• Counters are used to count digital signals.
• Integrators are used to integrate analog inputs.
• Operating time counters are used to measure the length of time that digital signals have
been active.
Saved counter and integrator statuses can be evaluated on a PC using the evaluation software
PCA3000. The last saved counter or integrator status can be displayed in the Visualization
menu using the Counters/Integrators function.
Chapter 7.10 "Counters/Integrators", page 78
13.17.1 General settings
Setup dialog
Parameter
Parameter Selection/settings Description
Synch. time 00:00:00 to 23:59:59 Synchronization time for completion and
restart of counters or integrators for
which the "Type" parameter is config-
ured as "Periodical", "Daily", or
"Weekly".
Start 00:00:00 to 23:59:59 Start time of counters or integrators for
which the "Type" parameter is config-
ured as "Daily (Start...End)".
End 00:00:00 to 23:59:59 End time of counters or integrators for
which the "Type" parameter is config-
ured as "Daily (Start...End)".
To Next Page
