Verifying the M7i Router Parts Received
A packing list is included in each shipment. Check the parts in the shipment against the
items on the packing list. The packing list specifies the part numbers and descriptions of
each part in your order.
If any part is missing, contact a customer service representative.
A fully configured router contains the router chassis with installed components, listed in
Table 55 on page 107, and an accessory box, which contains the parts listed in
Table 56 on page 107. The parts shipped with your router can vary depending on the
configuration you ordered.
Table 55: Generic Inventory of Router Components Installed in the M7i Chassis
QuantityComponent
Up to 4PIC
1 (2-port Fast Ethernet or 1-port Gigabit
Ethernet)
FIC
1Routing Engine
1Midplane
1CFEB or CFEB-E
1Fan tray
1 or 2Power supply
2Mounting brackets
Depends on router configurationBlank panels for slots without components
Table 56: Accessory Box Parts List
QuantityPart
4Screws, Screw, Pan hd, Phil, 12-24 x 1/2", self-tapping
4Screws, Flat Hd, Phil, 5 x 10.5mm Long, 1.6mm Pitch,
self-tapping
2Terminal lugs, 16-AWG to 14-AWG, #6 stud, ring terminal,
vinyl insulated
9 (2 per power supply)Terminal fork lugs, 14-AWG, #6, 0.25 Wide, insulation
strain relieved, for DC power cables
107Copyright © 2019, Juniper Networks, Inc.
Chapter 15: Unpacking the M7i
To Next Page
Loading...
Need help?
General
