Juniper M7i Hardware Guide

FIC Specifications for the M7i Router
Table 33 on page 45 lists the specifications for the type of network cable accepted by
the FIC. For information about the network cables for the PICs in your router, refer to the
M7i Multiservice Edge Router Interface Module Reference.
Table 33: FIC Specifications
Router
Receptacle
Maximum
LengthCable Supplied
Cable
SpecificationInterface Type
RJ-45328 ft (100 m)NoRJ-45
connectors (one
for each port);
MDI
noncrossover
2-port Fast
Ethernet FIC
LC656 ft/200 m
reach on
62.5/125
micrometer
multimode fiber
(MMF) 1640
ft/500 m reach
on 50/125
micrometer MMF
NoDuplex LC1-port Gigabit
Ethernet FIC with
SX SFP
LC6.2 mile/10 km
reach on 9/125
micrometer
single-mode
fiber (SMF)
NoDuplex LC1-port Gigabit
Ethernet FIC with
LX SFP
LC43.5 mile/70 km
reach on 8.2
micrometer SMF
NoDuplex LC1-port Gigabit
Ethernet FIC with
LH SFP
Related
Documentation
M7i PICs Description on page 46•
• M7i Fixed Interface Card (FIC) Description on page 44
• Connecting FIC and PIC Cables to the M7i Router on page 120
M7i FIC LEDs
Two large alarm LEDs are located on the right of the FIC (see Figure 14 on page 44 and
Figure 15 on page 44). The circular red LED lights to indicate a critical condition that can
result in a system shutdown. The triangular yellow LED lights to indicate a less severe
condition that requires monitoring or maintenance. Both LEDs can be lit simultaneously.
To deactivate red and yellow alarms, you must clear the condition that caused the alarm.
Table 34 on page 46 describes the alarm LEDs in more detail.
45Copyright © 2019, Juniper Networks, Inc.
Chapter 6: Line Card Components and Descriptions

Juniper M7i Specifications

General

Brand	Juniper
Model	M7i
Category	Network Router
Language	English