Juniper M7i - Figure 73: Placing a Component into an Electrostatic Bag

Figure 73 on page 229) . If you are returning a component, place it in an electrostatic
bag before packing it.
Figure 73: Placing a Component into an Electrostatic Bag
Related
Documentation
• Definition of Safety Warning Levels on page 223
• General Safety Warnings for Juniper Networks Devices on page 226
• M7i AC Power Electrical Safety Guidelines and Warnings on page 254
• M7i DC Power Electrical Safety Guidelines on page 255
229Copyright © 2019, Juniper Networks, Inc.
Chapter 33: General Safety Guidelines and Warnings