Intrabuilding Ports Warning
WARNING: The intrabuilding ports of the equipment or subassembly are
suitable for connection to intrabuilding or unexposed wiring or cabling only.
The intrabuilding ports of the equipment or subassembly MUST NOT be
metallicallyconnected to interfacesthatconnect to the Outside Plant (OSP)
or its wiring. These interfaces are designed for use as intrabuilding interfaces
only (Type 2 or Type 4 ports as described in GR-1089) and require isolation
from the exposed OSP cabling. The addition of Primary Protectors is not
sufficient protection in order to connect these interfaces metallically to OSP
wiring.
Installation Instructions Warning
WARNING: Readtheinstallation instructions before youconnectthe hardware
equipment to a power source.
Waarschuwing Raadpleeg de installatie-aanwijzingenvoordat u hetsysteem
met de voeding verbindt.
Varoitus Lueasennusohjeetennen järjestelmänyhdistämistä virtalähteeseen.
Attention Avantde brancherlesystème sur la source d'alimentation, consulter
les directives d'installation.
Warnung Lesen Sie die Installationsanweisungen, bevor Sie das System an
die Stromquelle anschließen.
Avvertenza Consultarele istruzioni di installazione prima di collegareil sistema
all'alimentatore.
Advarsel Les installasjonsinstruksjonene før systemet kobles til strømkilden.
Aviso Leia as instruções de instalação antes de ligar o sistema à sua fonte
de energia.
¡Atención! Ver las instrucciones de instalación antes de conectar el sistema
a la red de alimentación.
Varning! Läs installationsanvisningarna innan du kopplar systemet till dess
strömförsörjningsenhet.
Rack-Mounting Requirements and Warnings
Ensure that the equipment rack into which the chassis is installed is evenly and securely
supported, to avoid the hazardous condition that could result from uneven mechanical
loading.
Copyright © 2019, Juniper Networks, Inc.234
M7i Multiservice Edge Router Hardware Guide
To Next Page
Loading...
Need help?
General
