a commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. Operation of this equipment
in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
Related
Documentation
•
Compliance Statements for Environmental Requirements
Batteries in this product are not based on mercury, lead, or cadmium substances. The
batteries used in this product are in compliance with EU Directives 91/157/EEC, 93/86/EEC,
and 98/101/EEC. The product documentation includes instructional information about
the proper method of reclamation and recycling.
Compliance Statements for NEBS for the M7i Router
•
The equipment is suitable for installation as part of the Common Bonding Network
(CBN).
•
The equipment is suitable for installation in locations where the National Electrical
Code (NEC) applies.
•
The battery return connection is to be treated as an isolated DC return (that is, DC-I),
as defined in GR-1089-CORE.
•
You must provision a readily accessible device outside of the equipment to disconnect
power. The device must also be rated based on local electrical code practice.
Related
Documentation
Compliance Statements for Acoustic Noise for the M7i Router
The router complies with NEBS Level 3 requirements:
•
GR-63-CORE: NEBS, Physical Protection
•
GR-1089-CORE: EMC and Electrical Safety for Network Telecommunications Equipment
Related
Documentation
Agency Approvals for M7i Routers on page 261•
• Compliance Statements for NEBS for the M7i Router on page 264
• Compliance Statements for EMC Requirements for the M7i Router (European
Community) on page 262
• Compliance Statements for Environmental Requirements on page 264
Copyright © 2019, Juniper Networks, Inc.264
M7i Multiservice Edge Router Hardware Guide
To Next Page
Loading...
