To connect the new cable, follow these steps:
1. Plug the female end of the replacement serial cable into the CONSOLE or AUX/MODEM
port (see “Routing Engine Interface Ports” on page 145).
2. Tighten the screws on the connector.
3. Power on the auxiliary or console device.
Figure 46: Console and Auxiliary Serial Port Connector
See Also Fiber-Optic and Network Cable Specifications for the M7i Router on page 91•
• M7i Chassis Description on page 11
• FIC Specifications for the M7i Router on page 45
• Replacing the Management Ethernet Cable on page 145
Related
Documentation
Fiber-Optic and Network Cable Specifications for the M7i Router on page 91•
• M7i Chassis Description on page 11
• FIC Specifications for the M7i Router on page 45
Replacing the Management Ethernet Cable
To replace the management Ethernet cable:
1. Press the tab on the connector on the management Ethernet cable and pull the
connector straight out of the port. Figure 44 on page 145 shows the connector.
2. Disconnect the cable from the network device.
Copyright © 2019, Juniper Networks, Inc.146
M7i Multiservice Edge Router Hardware Guide
To Next Page
Loading...
Need help?
General
