Juniper M7i - Chapter 18 Connecting the M7 I to External Devices; Tools and Parts Required for M7 I Router Connections; Connecting the M7 I Router to Management and Alarm Devices

CHAPTER 18
Connecting the M7i to External Devices
•
Tools and Parts Required for M7i Router Connections on page 115
•
Connecting the M7i Router to Management and Alarm Devices on page 115
•
Connecting the M7i Router to a Network for Out-of-Band Management on page 118
•
Connecting the M7i Router to a Management Console or Auxiliary Device on page 119
•
Connecting FIC and PIC Cables to the M7i Router on page 120
Tools and Parts Required for M7i Router Connections
To connect the router to management devices and PICs and to power on the router, you
need the following tools and parts:
•
Electrostatic discharge (ESD) grounding wrist strap
Related
Documentation
M7i Router Power Requirements on page 79•
• M7i Router Site Preparation Checklist on page 73
Connecting the M7i Router to Management and Alarm Devices
After you have installed the router into the rack, connect the router to one or more external
devices for management and service operations.
To connect external devices, perform the procedures described in the following topics:
•
Connecting the M7i Router to a Network for Out-of-Band Management on page 116
•
Connecting the M7i Router to a Management Console or Auxiliary Device on page 116
115Copyright © 2019, Juniper Networks, Inc.