Connecting Power to a DC-Powered M7i Router

Connect DC power to the router by inserting power cables into the field-wiring

terminals on the faceplate of each power supply. Power and grounding cables are

not supplied with the router. For information about the required cable type, see M7i

Chassis Grounding, Connection, and Cable Specifications.

NOTE: The router must be connected to at least two separate external DC power

sources.

CAUTION: There is no standard color coding for DC power cables. The color coding

used by the external DC power source at your site determines the color coding for

the leads on the power cables that attach to the terminal studs on each power supply.

You must ensure that power connections maintain the proper polarity. The power

source cables might be labeled (+) and (–) to indicate their polarity.

To connect DC power to the router (see Figure 1):

1. Verify that there is no power flowing from either external power source, so that

the voltage across the leads of the power cables is 0 V. Ensure that there is no

chance that the cable leads might become active during the procedure.

2. For each power supply, verify that the power switch on the power supply faceplate

is in the OFF (O) position.

3. Connect the grounding cable to a proper earth ground for each external DC

power sources, if it is not already.

4. Verify that a licensed electrician has attached the cable lug provided with the

router to the grounding cable.

5. Using a number 2 Phillips screwdriver, remove the screws next to the grounding

symbol above the power supplies on the chassis rear. Secure the grounding cable

lug to the chosen grounding point by reinstalling and tightening the screws.

6. Verify that a licensed electrician has attached a listed power cable lug to each

power source cable.

7. Loop the power cables through the hook located on the faceplate to the right of

the field-wiring terminals.

8. Depending on the type of power cable lugs used, loosen or remove the screws

on the field-wiring terminals.

9. Insert the power cable lugs into the appropriate field-wiring terminals. Using a

number 1 Phillips screwdriver, turn the screw on each field-wiring terminal

clockwise to secure the power cable lug. Apply between 8 lb-in. (.9 Nm) and 9

lb-in. (1.02 Nm) of torque to each screw.

a. Insert the positive (+) source cable into the return terminal, which is labeled

RTN.

Connecting Power to a DC-Powered M7i Router ■ 1

Juniper M7i - Page 38

Other manuals for Juniper M7i